Material.: PS,PET,PP,OPS
Forming area (VxH): 750x530
Depth of draw: 120 mm
Other Specifications
Form, cut and stack
-Forming by vacuum and compressed air.
-Cutting in line with shafts in press and final station for stacking and counting.
-The plates move with a hydraulic system.(forming and cutting)
-Stacking is pneumatic.
-18.000 working hours
-Very good condition
-Suitable for PP-
- preheater .
UNWINDER
Motro power: 1,1 kw
Bobbin holder: Single position
Max. bobbin diameter: 1200 mm
Unwinding is automatic
THERMOFORMING MACHINE
Max. tool size: 750 x 530 mm(max. size without possibility of chain rails spreading)
Max.Positive depth: 120 mm
Max. Negative depth: 120 mm
Sheet width: 150-780 mm
Sheet pitch max. 530 mm
Max. sheet thickness for polystyrene: 1,8 mm
Max. sheet thickness for EPS: 3 mm
Max. platen stroke(upper/lower): 140 mm
Heater length: 1570 mm
Clamping force each platen: 16500 daN
Upper heater installed power: 31,2 kw
Lower heater installed power: 31,2 kw
Dry cycles: 40 cycles per minute
Vacuum pump motor power: 2,2 kw
Hydraulic powerpack motor power: 34 kw
Sheet index motor power: 4 kw
Working air pressure: 7 bar
Water consumption at +12 degrees c
Air consumption at 7 bar per cycle 50
Air compressor rating: 3000 LT/1
Chiller capacity requiered: 34000 frig/h
CUTTING PRESS:
Max. cut dimensions: 730x500 mm
Max. height forming upwards: 120 mm
Max. height forming downwards: 120 mm
Platen clamping force: 50000 daN at 1 mm
Upper platen stroke: 150 mm
Lower platen stroke: 150 mm
Installed power: 7,8 kw
Now the machine is working with OPS 710 mm x 0,38 mm and 20 cycles/ min.
What's new Rss
Contact Seller
More adverts from